Hi,
I am trying to understand the new PCMCIA configuration. So far I am trying
to use the kernel PCMCIA driver. The yenta_socket driver is working fine.
Using 2.4.0, and cardmgr 3.1.23
When I insert my Iomega Clik drive, cardmgr correctly identifies it as an ATA
Fixed Disk and loads ide_cs. ide_cs does the ide_probe and correctly assumes
that the drive is an ide-floppy. However at this point it doesn't seem to
even try to load the module. KMOD is set to y in .config
If I preload the ide-floppy module everything loads up fine and I can use the
drive perfectly. However, when I do a cardctl eject 0, everything screws up.
The eject command says it works, unlinks ide_cs, but seems to leave
ide-floppy working! and yes, I have run depmod -a about a zillion times.
modprobe -nv finds the modules no problem.
Any pointers on where or what is wrong here?
Thanks
--Paul Bristow ide-floppy maintainer http://paulbristow.net/linux/idefloppy.html
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Jan 23 2001 - 21:00:16 EST