But I want it to be 115200, not 38400. Still not quite fixed.
Niels Kristian Bech Jensen wrote:
>
> > The 2.1.66 kernel seems to have trouble on my machine
> > when setting baud rates.. I normally use setserial /dev/modem spd_vhi
> > to specify 115200, but the actual rate used is more like 9600 instead.
> >
> > Ports are just standard motherboard stuff on an ASUS board (16550A..).
> >
> > Not sure where to begin looking, other than at the extensive driver
> > updates in 2.1.66..
> >
> Does this patch solve your problem. It did for me but I don't know if it
> solves the whole problem:
>
> --- linux/drivers/char/serial.c.orig Wed Nov 26 06:55:52 1997
> +++ linux/drivers/char/serial.c Thu Nov 27 06:52:18 1997
> @@ -1376,7 +1376,7 @@
> /* Determine divisor based on baud rate */
> baud = tty_get_baud_rate(info->tty);
> baud_base = info->state->baud_base;
> - if (baud == 38400)
> + if (baud == 38400 && (info->flags & ASYNC_SPD_MASK) == ASYNC_SPD_CUST)
> quot = info->state->custom_divisor;
> else {
> if (baud == 134)
>
> --
> Med venlig hilsen / Best regards
> nkbj@image.dk
> Niels Kristian Bech Jensen http://www.image.dk/~nkbj/
-- mlord@pobox.com The Linux IDE guy