PROMLIB: Sun IEEE Boot Prom 3.7.0 1997/01/09 13:06
ARCH: SUN4U
Ethernet address: 08:00:20:8a:2e:d1
Found CPU 0 <node=f0071264,mid=0>
Found CPU 1 <node=f00715d0,mid=1>
Found 2 CPU prom device tree node(s).
IOMMU: IMPL[0] VERS[0] SYSIO mapped at fffff9fe00000000
sbus0: Clock 25.0 MHz
dma0: HME DVMA gate array
cgsix0 at 0x00000000 VA fffff9ff00800000 TEC Rev 4 CPU sparc Rev b
Console: 16 point font, 864 scans
Console: colour SUN 128x54, 1 virtual console (max 63)
Calibrating delay loop.. ok - 398.95 BogoMIPS
Memory: 126288k available (1104k kernel code, 2872k data, 88k init) [fffff80000000000,fffff80007f52000]
Swansea University Computer Society NET3.039 for Linux 2.1
NET3: Unix domain sockets 0.16 for Linux NET3.038.
Swansea University Computer Society TCP/IP for NET3.037
IP Protocols: IGMP, ICMP, UDP, TCP
Linux version 2.1.47 (davem@tanya.rutgers.edu) (gcc driver version 2.7.2 snapshot 970621 executing gcc version 2.7.2) #6 Mon Jul 28 01:45:45 EDT 1997
POSIX conformance testing by UNIFIX
Entering UltraSMPenguin Mode...
Calibrating delay loop.. ok - 399.77 BogoMIPS
Total of 2 processors activated (798.72 BogoMIPS).
Starting kswapd v 1.23
Sparc Zilog8530 serial driver version 1.43
tty00 at 0xfffc2004 (irq = 40) is a Zilog8530
tty01 at 0xfffc2000 (irq = 40) is a Zilog8530
tty02 at 0xfffae004 (irq = 40) is a Zilog8530
tty03 at 0xfffae000 (irq = 40) is a Zilog8530
Sun TYPE 4 keyboard detected without keyclick
Sun Mouse-Systems mouse driver version 1.00
Ramdisk driver initialized : 16 ramdisks of 4096K size
md driver 0.35 MAX_MD_DEV=4, MAX_REAL=8
esp0: IRQ 32 SCSI ID 7 Clock 40 MHz CCF=8 Time-Out 167 NCR53C9XF(espfast) detected
esp0: FAST chip is fasHME (family=10, version=5)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP366-HME
scsi : 1 host.
Vendor: SEAGATE Model: ST32171W SUN2.1G Rev: 7462
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Vendor: SEAGATE Model: ST32171W SUN2.1G Rev: 7462
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
Vendor: TOSHIBA Model: XM-5401TASUN4XCD Rev: 1036
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
scsi : detected 1 SCSI cdrom 2 SCSI disks total.
esp0: Disabling DISCONNECT for target 0 lun 0
esp0: 16 byte WIDE transfers enabled for target 0.
esp0: target 0 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II]
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4157201 [2029 MB] [2.0 GB]
esp0: Disabling DISCONNECT for target 1 lun 0
esp0: 16 byte WIDE transfers enabled for target 1.
esp0: target 1 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 4157201 [2029 MB] [2.0 GB]
sunhme.c:v1.2 10/Oct/96 David S. Miller (davem@caipfs.rutgers.edu)
eth0: HAPPY MEAL 10/100baseT Ethernet 08:00:20:8a:2e:d1
Partition check:
sda: sda1 sda2 sda3
sdb: sdb1 sdb2 sdb3
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 50904k swap-space (priority -1)
lo UP fl=0000004b pa=7F000001/FF000000 brd=7FFFFFFF dst=00000000
lo changes brd 7FFFFFFF -> 7FFFFFFF
eth0 UP fl=00001043 pa=80066F0D/FFFF0000 brd=8006FFFF dst=00000000
eth0 changes netmask FFFF0000 -> FFFFFF00
eth0 changes brd 8006FFFF -> 80066FFF
route forgot to specify route netmask.
eth0: Link is up using internal transceiver at 10Mb/s, Half Duplex.