[PATCH v5 1/3] dt-bindings: usb: mtk-xhci: add a property for Gen1 isoc-in transfer issue

[Chunfeng Yun]

For Gen1 isoc-in endpoint on controller before about SSUSB IPM v1.6.0, it
still send out unexpected ACK after receiving a short packet in burst
transfer, this will cause an exception on connected device, specially for
a 4k camera.
Add a quirk property "rx-fifo-depth" to work around this hardware issue,
prefer to use 3k bytes;
The side-effect is that it may cause performance drop about 10%, including
bulk transfer.

Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>
Signed-off-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
---
v5: fix typos, add acked-by and reviewed-by
v4: change rx-fifo size in bytes
v3: add fifo depth unit, change the value range from 0-3 to 1-4
v2: change 'mediatek,rxfifo-depth' to 'rx-fifo-depth'
---
 .../devicetree/bindings/usb/mediatek,mtk-xhci.yaml    | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml b/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml
index e9644e333d78..924fd3d748a8 100644
--- a/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml
+++ b/Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.yaml
@@ -124,6 +124,17 @@ properties:
       defined in the xHCI spec on MTK's controller.
     default: 5000
 
+  rx-fifo-depth:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      It is a quirk used to work around Gen1 isoc-in endpoint transfer issue
+      that still send out unexpected ACK after device finishes the burst
+      transfer with a short packet and cause an exception, specially on a 4K
+      camera device, it happens on controller before about IPM v1.6.0;
+      the side-effect is that it may cause performance drop about 10%,
+      including bulk transfer, prefer to use 3k here. The size is in bytes.
+    enum: [1024, 2048, 3072, 4096]
+
   # the following properties are only used for case 1
   wakeup-source:
     description: enable USB remote wakeup, see power/wakeup-source.txt
-- 
2.18.0