Re: [PATCH v3 1/2] dt-bindings: iio: frequency: add admfm2000

[Krzysztof Kozlowski]

On 23/11/2023 07:13, Paller, Kim Seer wrote:
>>> ---
>>> V2 -> V3: Adjusted indentation to resolve wrong indentation warning.
>>>           Changed node name to converter. Updated the descriptions to clarify
>>>           the properties.
>>
>>
>>> +title: ADMFM2000 Dual Microwave Down Converter
>>> +
>>> +maintainers:
>>> +  - Kim Seer Paller <kimseer.paller@xxxxxxxxxx>
>>> +
>>> +description:
>>> +  Dual microwave down converter module with input RF and LO frequency
>> ranges
>>> +  from 0.5 to 32 GHz and an output IF frequency range from 0.1 to 8 GHz.
>>> +  It consists of a LNA, mixer, IF filter, DSA, and IF amplifier for each down
>>> +  conversion path.
>>> +
>>> +properties:
>>> +  compatible:
>>> +    enum:
>>> +      - adi,admfm2000
>>> +
>>> +  switch1-gpios:
>>> +    items:
>>> +      - description:
>>> +          Setting B15 GPIO to high and B16 GPIO to low will result in channel 1
>>> +          being in Direct IF mode.
>>> +      - description:
>>> +          Setting B15 GPIO to low and B16 GPIO to high will result in channel 1
>>> +          being in Mixer mode.
>>
>> This still does not tell which one is B15 and which is B16. I am asking
>> this for third time.
>>
>> items:
>>   - description: B15 GPIO, when high (and B16 low) channel 1 is in
>> Direct IF mode
> 
> I understand now, thank you. I was also wondering if this applies to the 
> attenuation-gpios, or if I should keep it as is?

Yes, something like this applies to all your properties with multiple
entries. You need to define the order.

Best regards,
Krzysztof