[PATCH 03/11] drm/msm/dpu: use hsync/vsync polarity set by the encoder

[Arnaud Vrac]

Do not override the hsync/vsync polarity passed by the encoder when
setting up intf timings. The same logic was used in both the encoder and
intf code to set the DP and DSI polarities, so those interfaces are not
impacted. However for HDMI, the polarities were overriden to static
values based on the vertical resolution, instead of using the actual
mode polarities.

Signed-off-by: Arnaud Vrac <avrac@xxxxxxxxxx>
---
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 16 +++-------------
 1 file changed, 3 insertions(+), 13 deletions(-)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
index 84ee2efa9c664..9f05417eb1213 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
@@ -104,7 +104,7 @@ static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx,
 	u32 active_h_start, active_h_end;
 	u32 active_v_start, active_v_end;
 	u32 active_hctl, display_hctl, hsync_ctl;
-	u32 polarity_ctl, den_polarity, hsync_polarity, vsync_polarity;
+	u32 polarity_ctl, den_polarity;
 	u32 panel_format;
 	u32 intf_cfg, intf_cfg2 = 0;
 	u32 display_data_hctl = 0, active_data_hctl = 0;
@@ -191,19 +191,9 @@ static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx,
 	}
 
 	den_polarity = 0;
-	if (ctx->cap->type == INTF_HDMI) {
-		hsync_polarity = p->yres >= 720 ? 0 : 1;
-		vsync_polarity = p->yres >= 720 ? 0 : 1;
-	} else if (ctx->cap->type == INTF_DP) {
-		hsync_polarity = p->hsync_polarity;
-		vsync_polarity = p->vsync_polarity;
-	} else {
-		hsync_polarity = 0;
-		vsync_polarity = 0;
-	}
 	polarity_ctl = (den_polarity << 2) | /*  DEN Polarity  */
-		(vsync_polarity << 1) | /* VSYNC Polarity */
-		(hsync_polarity << 0);  /* HSYNC Polarity */
+		(p->vsync_polarity << 1) | /* VSYNC Polarity */
+		(p->hsync_polarity << 0);  /* HSYNC Polarity */
 
 	if (!DPU_FORMAT_IS_YUV(fmt))
 		panel_format = (fmt->bits[C0_G_Y] |

-- 
2.40.0