[net-next PATCH v2 11/15] dt-bindings: net: dsa: qca8k: Document qca,sgmii-enable-pll

[Ansuel Smith]

Document qca,sgmii-enable-pll binding used in the CPU nodes to
enable SGMII PLL on MAC config.

Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
---
 Documentation/devicetree/bindings/net/dsa/qca8k.txt | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
index 208ee5bc1bbb..b9cccb657373 100644
--- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt
+++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
@@ -50,6 +50,12 @@ A CPU port node has the following optional node:
                           managed entity. See
                           Documentation/devicetree/bindings/net/fixed-link.txt
                           for details.
+- qca,sgmii-enable-pll  : For SGMII CPU port, explicitly enable PLL, TX and RX
+                          chain along with Signal Detection.
+                          This should NOT be enabled for qca8327.
+                          This can be required for qca8337 switch with revision 2.
+                          With CPU port set to sgmii and qca8337 it is advised
+                          to set this unless a communication problem is observed.
 
 For QCA8K the 'fixed-link' sub-node supports only the following properties:
 
-- 
2.32.0