On Mon, Aug 04, 2003 at 02:26:54PM -0400, Paul Blazejowski wrote:
>
> Patrick,
>
> I enabled CONFIG_SCSI_LOGGING=y in kernel then i used
> scsi_mod.scsi_logging_level=0x140 and scsi_mod.max_scsi_luns=1 when
> booting the kernel from lilo.I can see some debug information scroll on
> the screen and i did see ID0 LUN0 get probed even the correct transfer
> rate for the SCSI disk is set.I forgot but isn't there a key sequence
> when pressed it will stop the screen output like pause/break key?
>
> I have few screen snaps which can be viewed at
> http://www.blazebox.homeip.net:81/diffie/images/linux-2.6.0-test2/aic7xxx/
Yep, the shot that might have useful information is blurred.
I assume you are unable to use a serial console.
I can usually "Shift + page-up" as long as there is not too much data, and
depending on your console, AFAIR I can't pause my console output.
Also, does the adapter bios show the drive at boot time?
Hopefully Justin will add more useful suggestions for debugging.
-- Patrick Mansfield
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Thu Aug 07 2003 - 22:00:24 EST