Hello,
Please include me in CC´s for each response, cause I´m not reading the
list, THANKS.
[1] Boot failure with 2.3.99-pre6
[2] After downloading the kernel sources from ftp.kernel.org and compiling
it there´s no way to boot with the new kernel :(((
boot-message output follows :
...(everything fine until here)
kmem_free: Bad obj addr (objp=c12da0e0;name = dentry_cache)
Kernel BUG at slub.c:1661 !
Invalid operand: 0000
...(complete CPU and stack dump follows)
[3] kernel
[4] ---
[5] no oops message
[6] ---
[7]
[7.1] Base system SuSE 6.3
gcc 2.95.2
binutils 2.9.5.0.24
ldd (GNU libc) 2.1.3
Procps 2.0.6
Sh_utils 2.0
[7.2] AMD K6-2 400 (Stepping 9)
[7.3] ---
[7.4] ---
[7.5]
00:00.0 Host bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3] (rev
04)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
Latency: 16 set
Region 0: Memory at e0000000 (32-bit, prefetchable)
Capabilities: [a0] AGP version 1.0
Status: RQ=7 SBA+ 64bit- FW- Rate=x1,x2
Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3 AGP]
(prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0 set
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: fff00000-000fffff
Prefetchable memory behind bridge: fff00000-000fffff
BridgeCtl: Parity- SERR- NoISA+ VGA- MAbort- >Reset- FastB2B-
00:07.0 ISA bridge: VIA Technologies, Inc. VT82C586/A/B PCI-to-ISA [Apollo
VP] (rev 47)
Subsystem: VIA Technologies, Inc. MVP3 ISA Bridge
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop-
ParErr- Stepping+ SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0 set
00:07.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev
06) (prog-if 8a [Master SecP PriP])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 set
Region 4: I/O ports at e000
00:07.2 USB Controller: VIA Technologies, Inc. VT82C586B USB (rev 02)
(prog-if 00 [UHCI])
Subsystem: Unknown device 0925:1234
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 set, cache line size 08
Interrupt: pin D routed to IRQ 11
Region 4: I/O ports at e400
00:07.3 Host bridge: VIA Technologies, Inc. VT82C586B ACPI (rev 10)
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
00:12.0 Non-VGA unclassified device: Symbios Logic Inc. (formerly NCR)
53c810 (rev 01)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
Latency: 64 set
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at e800
Region 1: Memory at e8000000 (32-bit, non-prefetchable)
00:13.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20)
Subsystem: Netgear FA310TX
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 set
Interrupt: pin A routed to IRQ 9
Region 0: I/O ports at ec00
Region 1: Memory at e8001000 (32-bit, non-prefetchable)
Expansion ROM at e4000000 [disabled]
00:14.0 VGA compatible controller: NVidia / SGS Thomson (Joint Venture)
Riva128 (rev 10) (prog-if 00 [VGA])
Subsystem: Diamond Multimedia Systems Viper V330
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 3 min, 1 max, 64 set
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e5000000 (32-bit, non-prefetchable)
Region 1: Memory at e6000000 (32-bit, prefetchable)
Expansion ROM at e7000000 [disabled]
[7.6] NCR 53c7xx (SCSI-II PCI controller)
[7.7] --
Thanks for any answer and suggestions
greetings
Markus
-- Sent through GMX FreeMail - http://www.gmx.net- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon May 15 2000 - 21:00:18 EST