Hi Doug,
I've compiled linux 2.2.16pre2 with the aicxxx scsi patch v5.1.29
and I am still getting the scsi data overrun error on bootup for my
Western Digital 9Gig drive. System is Dell optiplex gx1 333mhz with
2940U2W controller. See dmesg below
Mike
Linux version 2.2.16pre2 (root@DosLinux) (gcc version egcs-2.91.66 19990314 (egcs-1.1.2 release)) #1 SMP Thu May 4 21:50:08 /etc/localtime 2000
mapped APIC to ffffe000 (0031c000)
Detected 331715 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 661.91 BogoMIPS
Memory: 127208k/131072k available (1288k kernel code, 420k reserved, 2072k data, 84k init)
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
VFS: Diskquotas version dquot_6.4.0 initialized
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
per-CPU timeslice cutoff: 99.92 usecs.
CPU0: Intel Pentium II (Deschutes) stepping 01
SMP motherboard not detected. Using dummy APIC emulation.
PCI: PCI BIOS revision 2.10 entry at 0xfcaee
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.12)
Real Time Clock Driver v1.09
RAM disk driver initialized: 16 RAM disks of 4096K size
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
hdc: QUANTUM FIREBALL_TM1280A, ATA DISK drive
hdd: TOSHIBA CD-ROM XM-6202B, ATAPI CDROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hdc: QUANTUM FIREBALL_TM1280A, 1222MB w/76kB Cache, CHS=2484/16/63, DMA
hdd: ATAPI 32X CD-ROM drive, 256kB Cache
Uniform CD-ROM driver Revision: 3.08
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
(scsi0) <Adaptec AIC-7895 Ultra SCSI host adapter> found at PCI 0/14/0
(scsi0) Wide Channel A, SCSI ID=7, 32/255 SCBs
(scsi0) Cables present (Int-50 NO, Int-68 YES, Ext-68 NO)
(scsi0) Downloading sequencer code... 383 instructions downloaded
(scsi1) <Adaptec AIC-7895 Ultra SCSI host adapter> found at PCI 0/14/1
(scsi1) Narrow Channel B, SCSI ID=7, 32/255 SCBs
(scsi1) Cables present (Int-50 NO, Ext-50 NO)
(scsi1) Downloading sequencer code... 383 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.29/3.2.4
<Adaptec AIC-7895 Ultra SCSI host adapter>
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.29/3.2.4
<Adaptec AIC-7895 Ultra SCSI host adapter>
scsi : 2 hosts.
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 8.
(scsi0:0:0:0) Data overrun detected in Data-In phase, tag 1;
Have seen Data Phase. Length=255, NumSGs=1.
sg[0] - Addr 0x7fec260 : Length 255
Vendor: WDIGTL Model: WDE9100-1807A4 Rev: 1.30
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783204 [8683 MB] [8.7 GB]
Partition check:
sda: sda1 sda2 < sda5 sda6 sda7 >
hdc: [PTBL] [621/64/63] hdc1
UMSDOS 0.85g (compatibility level 0.4, fast msdos)
check_pseudo_root: mounted as root
check_pseudo_root: found //linux
check_pseudo_root: found sbin/init, enabling pseudo-root
UMSDOS: changed to alternate root
VFS: Mounted root (umsdos filesystem).
Freeing unused kernel memory: 84k freed
CSLIP: code copyright 1989 Regents of the University of California
SLIP: version 0.8.4-NET3.019-NEWTTY-MODULAR (dynamic channels, max=256).
SLIP linefill/keepalive option.
PPP: version 2.3.7 (demand dialling)
PPP line discipline registered.
PPP BSD Compression module registered
PPP Deflate Compression module registered
ad1848/cs4248 codec driver Copyright (C) by Hannu Savolainen 1993-1996
YM3812 and OPL-3 driver Copyright (C) by Hannu Savolainen, Rob Hooft 1993-1996
3c59x.c:v0.99H 11/17/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
eth0: 3Com 3c905B Cyclone 100baseTx at 0xdc00, 00:c0:4f:78:7a:80, IRQ 11
8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
MII transceiver found at address 24, status 786d.
MII transceiver found at address 0, status 786d.
Enabling bus-master transmits and whole-frame receives.
imm: Version 2.03 (for Linux 2.0.0)
imm: parport reports no devices.
scsi : 2 hosts.
VFS: Disk change detected on device ide1(22,64)
ISO 9660 Extensions: Microsoft Joliet Level 3
ISOFS: changing to secondary root
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun May 07 2000 - 21:00:17 EST