Hi,
the above works with 2.2.13, but no fun with pre-6, pre-5 and 2.3.48.
This is a K6-2, ALI M1541, Tulip card
lspci:
[...]
00:0c.0 Ethernet controller: Digital Equipment Corporation DECchip 21041 [Tulip Pass 3] (rev 21)
Subsystem: Standard Microsystems Corp [SMC]: Unknown device 2009
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 set
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at e400 [size=128]
Region 1: Memory at d7001000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at <unassigned> [disabled] [size=256K]
[...]
messages:
Apr 28 15:50:20 sc1 kernel: Linux Tulip driver version 0.9.4.3 (Apr 14, 2000)
Apr 28 15:50:20 sc1 kernel: eth0: Digital DC21041 Tulip rev 33 at 0xe400, 21041 mode, 00:E0:29:2C:85:EC, IRQ 10.
Apr 28 15:50:20 sc1 kernel: eth0: 21041 Media table, default media 0400 (10baseT).
Apr 28 15:50:20 sc1 kernel: eth0: 21041 media #0, 10baseT.
Apr 28 15:50:20 sc1 kernel: eth0: 21041 media #4, 10baseT-FD.
Apr 28 15:50:20 sc1 kernel: eth0: No 21041 10baseT link beat, Media switched to 10base2.
Attached are tcpdumps: 13.log 2.2.13 working, 48.log 2.3.48 nope,
pre6-log nope.
Is this pilot error or a kernel problem?
Ralf
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Apr 30 2000 - 21:00:15 EST