> Folks -
>
> Just recently as I was "make config"ing for my new system, I noticed
> that every mouse type is prompted for. Since I don't even HAVE a mouse
> attached, I felt that perhaps we could encapsulate the entire mouse
> config (drivers/char/Config.in) inside of a "CONFIG_MOUSE" option.
I think that we probably ought to point out it is mouse support for non
serial mice...
> --- drivers/char/Config.old Mon May 20 12:59:21 1996
> +++ drivers/char/Config.in Mon May 20 13:00:27 1996
> @@ -14,13 +14,19 @@
> fi
> tristate 'SDL RISCom/8 card support' CONFIG_RISCOM8
> tristate 'Parallel printer support' CONFIG_PRINTER
> -tristate 'Logitech busmouse support' CONFIG_BUSMOUSE
> -tristate 'PS/2 mouse (aka "auxiliary device") support' CONFIG_PSMOUSE
> -if [ "$CONFIG_PSMOUSE" != "n" ]; then
> - bool 'C&T 82C710 mouse port support (as on TI Travelmate)' CONFIG_82C710_MOUSE
> +
> +
+bool 'Non-serial Mouse Support' CONFIG_MOUSE
> +if [ "$CONFIG_MOUSE" = "y" ]; then
> + tristate 'Logitech busmouse support' CONFIG_BUSMOUSE
> + tristate 'PS/2 mouse (aka "auxiliary device") support' CONFIG_PSMOUSE
> + if [ "$CONFIG_PSMOUSE" != "n" ]; then
> + bool 'C&T 82C710 mouse port support (as on TI Travelmate)' CONFIG_82C710_MOUSE
> + fi
> + tristate 'Microsoft busmouse support' CONFIG_MS_BUSMOUSE
> + tristate 'ATIXL busmouse support' CONFIG_ATIXL_BUSMOUSE
> fi
> -tristate 'Microsoft busmouse support' CONFIG_MS_BUSMOUSE
> -tristate 'ATIXL busmouse support' CONFIG_ATIXL_BUSMOUSE
> +
> bool 'Support for user misc device modules' CONFIG_UMISC
>
> bool 'QIC-02 tape support' CONFIG_QIC02_TAPE
Alan