> Hello:
>
> I think something got broken after 2.2.10 in the SCSI code for the
> Adaptec 7XXX adapters....Below is my boot up info for 2.2.10 (last one
> that appears to work) and then 2.2.11, 2.2.12 and 2.2.13 all fail
> similarly. They were complied with the same options using
> Dec 5 09:50:55 eagle kernel: scsi : 1 host.
> Dec 5 09:50:55 eagle kernel: Vendor: SEAGATE Model: ST32550N
> Rev:0021
> Dec 5 09:50:55 eagle kernel: Type: Direct-Access
> ANSISCSI revision: 02
> Dec 5 09:50:55 eagle kernel: Detected scsi disk sda at scsi0, channel
>
> Under 2.2.11,2.2.12 or 2.2.13 I get the following error:
> --------------------------------------------------------
> scsi: Aborting Command due to timeout pid 11,scsi0,channel 0,id3,lun 0
> Testing Unit Ready 00 00 00 00 00
>
> and it just keeps repeating and the system will not boot.
I saw the same problem with an older Seagate drive here. A Barracuda
ST15150W just would not work on a 7890-based controller under any of
Doug's newer drivers. If I reverted back to the driver of circa-2.2.9 (I
think it was aic7xxx 5.1.10) it was just fine. This only occurred on a
7890 controller. The drive's previous home was in an older box with 2940A
controller (7880 chipset), where it worked (and continues to work) fine.
Steve
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/