And so it goes. It bounces between 10baseT and 100baseTx-FD.
The numeric constants don't change after the second line. It didn't come
back in 3 minutes so I did ifconfig eth0 don; ifconfig eth0 up and it
works again. Have not had this problem for a while so it must be the new
The card is Accton EN1207. Uptime is 2 days. No heavy network activity,
just normal nntp reading. IDE CD writing started about the same time.
Next CD writing did not cause the same problems (as expected).
K6-200, UP kernel.
>From dmesg:
tulip.c:v0.91g-ppc 7/16/99 becker@cesdis.gsfc.nasa.gov
eth0: Digital DS21140 Tulip rev 34 at 0x6400, 00:00:E8:2C:66:F7, IRQ 10.
eth0: EEPROM default media type Autosense.
eth0: Index #0 - Media 10baseT (#0) described by a 21140 non-MII
(0) block.
eth0: Index #1 - Media 100baseTx (#3) described by a 21140 non-MII
(0) block.
eth0: Index #2 - Media 10baseT-FD (#4) described by a 21140 non-MII
(0) block.
eth0: Index #3 - Media 100baseTx-FD (#5) described by a 21140 non-MII
(0) block.
eth0: MII transceiver #1 config 3100 status 7869 advertising 01e1.
---
Meelis Roos (mroos@tartu.cyber.ee)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/