> I have recently installed a 368 With RH 5.2 for some home
> routing use...... This is working fine, but now I want to
> recompile the kernel...
> Problem is, the machine has not enough disk space for the
> sources etc. So I decided to build it on an other machine, which
> was no problem. Putting the kernel on the other machine was ok
> too.....
> But now for the problem: How do I get modules from the one
> machine too het other, and how do I install the om the other
> machine???
Last time I was faced with this problem, I nfs mounted the kernel
subtree to the system I wanted them on, compiled the kernel on the
machine it was local to with the command...
Q> make dep clean modules zImage
...then went to the target machine and did the following...
Q> make modules_install
Q> cp arch/i386/boot/zImage /boot/vmlinuz-new
...and finally edited /etc/lilo.conf on that system to allow booting
from /boot/vmlinuz-new which I then tested before renaming it to be
the default boot kernel.
Best wishes from Riley.
+----------------------------------------------------------------------+
| There is something frustrating about the quality and speed of Linux |
| development, ie., the quality is too high and the speed is too high, |
| in other words, I can implement this XXXX feature, but I bet someone |
| else has already done so and is just about to release their patch. |
+----------------------------------------------------------------------+
* ftp://ftp.MemAlpha.cx/pub/rhw/Linux
* http://www.MemAlpha.cx/kernel.versions.html
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/