-if [ "$CONFIG_IPX" != "n" ]; then
+if [ "$CONFIG_IPX" != "n" -o "$CONFIG_INET" != "n" ]; then
tristate 'NCP filesystem support (to mount NetWare volumes)' CONFIG_NCP_FS
[ it was buggy and remains buggy ]
The problem appears if "$CONFIG_NET" = "n". Then networking Config.in
is NOT proocessed and neither CONFIG_IPX nor CONFIG_INET is set.
So The above condition is TRUE in both variants
( [ "" != "n" -o "" != "n" ] is of course true)
I think that the '!= "n"' clause should be used very carefully, especially
for variables from another section.
Regards
Andrzej
-- ======================================================================= Andrzej M. Krzysztofowicz ankry@mif.pg.gda.pl phone (48)(58) 347 14 61 Faculty of Applied Phys. & Math., Technical University of Gdansk- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/