I'm seeing the following on the console:
(scsi0:0:-1:-1) Scanning Channel for devices
SCSI: Aborting command due to timeout, pid 0, scsi 0, channel 0, id 0, lun 0
Test Unit Ready 00 00 00 00 00
SCSI host 0 abort (pid 0) timed out - resetting
SCSI bus is being reset for host 0 channel 0
(SCSI0:0:0:0) Device reset, Message buffer in use
SCSI host 0 channel 0 reset (pid 0) timed out - trying harder
The last 4 messages repeat indefinitely until <ctrl-alt-del>
A normal boot looks as follows:
(scsi0:0:-1:-1) Scanning channel for devices.
(scsi0:0:0:0) Synchronous at 10.0MHz, offset 15.
Vendor: SEAGATE Model: ST32550N Rev: 8303
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Vendor: HP Model: HP35480A Rev: T503
Type: Sequential-Access ANSI SCSI revision: 02
Vendor: FUJITSU Model: M2954S-512 Rev: 0147
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 4, lun 0
Vendor: SONY Model: CD-ROM CDU-76S Rev: 1.1c
Type: CD-ROM ANSI SCSI revision: 02
Vendor: QUANTUM Model: FIREBALL1280S Rev: 630C
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdc at scsi0, channel 0, id 6, lun 0
scsi : detected 3 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4165272 [2033 MB] [2.0 GB]
(scsi0:0:4:0) Synchronous at 10.0MHz, offset 15.
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 8498506 [4149 MB] [4.1 GB]
(scsi0:0:6:0) Synchronous at 10.0MHz, offset 8.
SCSI device sdc: hdwr sector= 512 bytes. Sectors= 2503872 [1222 MB] [1.2 GB]
System:
HP Vectra XU 6/150 (2x 150 ppro, KX Chipset)
128mb
Matrox Millennium I - 2mb
Onboard AIC7880 - firmware version 1.2
-- Tom Eastep COMPAQ Computer Corporation Enterprise Computing Group Tandem Division tom.eastep@compaq.com- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/