I am using an ncr 810 DTC card. Its worked fine. I upgraded to the 2.*
kernel AND I enabled disconnects so that when my HP35480 tape drive did a
backup, it wouldnt slow down the CONNER 1060S drive.
BTW, I DID upgrade the firmware in the Conner with teh BARUNIX.
Okay, so NOW I am getting sda failures, The drive goes offline now.
I wonder, is the drive spinning down automatically like the Seagates? I
cant do an hdparm -Z to a scsi device. Its not supported.
Should I perhaps disable disconnects?
I also have it always negotiate sync xfers and always 10 MHz xfer rate,
but that is the same as before.
~*-,._.,-*~'`^`'~*-,._.,-*~'`^`'~*-,._.,-*~'`^`'~*-,._.,-*~'`^`'~*-,._.,-*~
Jake Messinger 713-772-6690 jake@ams.com
Advanced Medical Systems, Inc. 800-324-8594 jake@uh.edu
Houston, Texas http://www.ams.com/~jake
~*-,._.,-*~'`^`'~*-,._.,-*~'`^`'~*-,._.,-*~'`^`'~*-,._.,-*~'`^`'~*-,._.,-*~
(Don't steal my squigglies)