Re: [PATCH 1/2] arm64: dts: rockchip: Add enable-strobe-pulldown to emmc phy on ROCK Pi 4

[Chen-Yu Tsai]

On Thu, Mar 28, 2024 at 3:09 PM Folker Schwesinger
<dev@xxxxxxxxxxxxxxxxxxxxx> wrote:
>
> On Thu Mar 28, 2024 at 6:39 AM CET, Chen-Yu Tsai wrote:
> > > @@ -648,7 +649,8 @@ &saradc {
> > >  &sdhci {
> > >         max-frequency  <150000000>;
> > >         bus-width  <8>;
> > > -       mmc-hs200-1_8v;
> >
> > Shouldn't this be kept around? The node should list all supported modes,
> > not just the highest one. Same for the other patch.
> >
>
> This is not necessary, mmc-hs400-1_8v implicitly activates the
> corresponding HS200 capability, see drivers/mmc/core/host.c:
>
> if (device_property_read_bool(dev, "mmc-hs200-1_8v"))
>         host->caps2 | MMC_CAP2_HS200_1_8V_SDR;
> /* ... */
> if (device_property_read_bool(dev, "mmc-hs400-1_8v"))
>         host->caps2 | MMC_CAP2_HS400_1_8V | MMC_CAP2_HS200_1_8V_SDR;

Looking at the initial commit for adding the hs400 properties,
it was also mentioned that hs400 support implies hs200 support.
It just wasn't explicitly spelled out in the bindings.

In that case, I think we're good here for this particular case.

> Kind regards
>
> Folker
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel