Re: [PATCH v2 3/3] arm64: dts: qcom: apq8016: Add Schneider HMIBSC board DTS

[Sumit Garg]

On Thu, 14 Mar 2024 at 15:36, Krzysztof Kozlowski
<krzysztof.kozlowski@xxxxxxxxxx> wrote:
>
> On 14/03/2024 10:36, Sumit Garg wrote:
> >>
> >> But it then broke dtbs_check.
> >
> > See following breakage afterwards:
> >
> > $ make qcom/apq8016-schneider-hmibsc.dtb dtbs_check
> > <snip>
> > /home/sumit/build/upstream/linux/arch/arm64/boot/dts/qcom/apq8016-schneider-hmibsc.dtb:
> > leds: led@5: Unevaluated properties are not allowed ('reg' was
> > unexpected)
> > from schema $id: http://devicetree.org/schemas/leds/leds-gpio.yaml#
> > /home/sumit/build/upstream/linux/arch/arm64/boot/dts/qcom/apq8016-schneider-hmibsc.dtb:
> > leds: led@6: Unevaluated properties are not allowed ('reg' was
> > unexpected)
> > from schema $id: http://devicetree.org/schemas/leds/leds-gpio.yaml#
> > /home/sumit/build/upstream/linux/arch/arm64/boot/dts/qcom/apq8016-schneider-hmibsc.dtb:
> > leds: '#address-cells', '#size-cells' do not match any of the regexes:
> > '(^led-[0-9a-f]$|led)', 'pinctrl-[0-9]+'
>
> That's obvious, I don't get what is the question. Adding not correct
> properties is not a solution and dtbs_check correctly tells you that.
>
> If you only opened absolutely any existing upstream source, you would
> see how the gpio leds are represented in DTS.
>

It looks like my reference example:
arch/arm64/boot/dts/qcom/apq8016-sbc.dts wasn't correct then. I will
drop unit addresses then.

-Sumit

> Best regards,
> Krzysztof
>