[PATCH RFC 02/21] media: cadence: csi2rx: configure DPHY before starting source stream

[Jai Luthra]

From: Pratyush Yadav <p.yadav@xxxxxx>

When the source device is operating above 1.5 Gbps per lane, it needs to
send the Skew Calibration Sequence before sending any HS data. If the
DPHY is initialized after the source stream is started, then it might
miss the sequence and not be able to receive data properly. Move the
start of source subdev to the end of the sequence to make sure
everything is ready to receive data before the source starts streaming.

Signed-off-by: Pratyush Yadav <p.yadav@xxxxxx>
Signed-off-by: Jai Luthra <j-luthra@xxxxxx>
---
 drivers/media/platform/cadence/cdns-csi2rx.c | 26 ++++++++++++++------------
 1 file changed, 14 insertions(+), 12 deletions(-)

diff --git a/drivers/media/platform/cadence/cdns-csi2rx.c b/drivers/media/platform/cadence/cdns-csi2rx.c
index 70b7f8a9e4f2..75e602c1d762 100644
--- a/drivers/media/platform/cadence/cdns-csi2rx.c
+++ b/drivers/media/platform/cadence/cdns-csi2rx.c
@@ -243,10 +243,6 @@ static int csi2rx_start(struct csi2rx_priv *csi2rx)
 
 	writel(reg, csi2rx->base + CSI2RX_STATIC_CFG_REG);
 
-	ret = v4l2_subdev_call(csi2rx->source_subdev, video, s_stream, true);
-	if (ret)
-		goto err_disable_pclk;
-
 	/* Enable DPHY clk and data lanes. */
 	if (csi2rx->dphy) {
 		reg = CSI2RX_DPHY_CL_EN | CSI2RX_DPHY_CL_RST;
@@ -256,6 +252,13 @@ static int csi2rx_start(struct csi2rx_priv *csi2rx)
 		}
 
 		writel(reg, csi2rx->base + CSI2RX_DPHY_LANE_CTRL_REG);
+
+		ret = csi2rx_configure_ext_dphy(csi2rx);
+		if (ret) {
+			dev_err(csi2rx->dev,
+				"Failed to configure external DPHY: %d\n", ret);
+			goto err_disable_pclk;
+		}
 	}
 
 	/*
@@ -295,14 +298,9 @@ static int csi2rx_start(struct csi2rx_priv *csi2rx)
 
 	reset_control_deassert(csi2rx->sys_rst);
 
-	if (csi2rx->dphy) {
-		ret = csi2rx_configure_ext_dphy(csi2rx);
-		if (ret) {
-			dev_err(csi2rx->dev,
-				"Failed to configure external DPHY: %d\n", ret);
-			goto err_disable_sysclk;
-		}
-	}
+	ret = v4l2_subdev_call(csi2rx->source_subdev, video, s_stream, true);
+	if (ret)
+		goto err_disable_sysclk;
 
 	clk_disable_unprepare(csi2rx->p_clk);
 
@@ -316,6 +314,10 @@ static int csi2rx_start(struct csi2rx_priv *csi2rx)
 		clk_disable_unprepare(csi2rx->pixel_clk[i - 1]);
 	}
 
+	if (csi2rx->dphy) {
+		writel(0, csi2rx->base + CSI2RX_DPHY_LANE_CTRL_REG);
+		phy_power_off(csi2rx->dphy);
+	}
 err_disable_pclk:
 	clk_disable_unprepare(csi2rx->p_clk);
 

-- 
2.43.0