[PATCH net-next 1/3] dt-bindings: net: dp83822: support configuring RMII master/slave mode

[Jérémie Dautheribes]

Add property ti,rmii-mode to support selecting the RMII operation mode
between:
	- master mode (PHY operates from a 25MHz clock reference)
	- slave mode (PHY operates from a 50MHz clock reference)

If not set, the operation mode is configured by hardware straps.

Signed-off-by: Jérémie Dautheribes <jeremie.dautheribes@xxxxxxxxxxx>
---
 .../devicetree/bindings/net/ti,dp83822.yaml      | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/ti,dp83822.yaml b/Documentation/devicetree/bindings/net/ti,dp83822.yaml
index 8f4350be689c..8f23254c0458 100644
--- a/Documentation/devicetree/bindings/net/ti,dp83822.yaml
+++ b/Documentation/devicetree/bindings/net/ti,dp83822.yaml
@@ -80,6 +80,22 @@ properties:
            10625, 11250, 11875, 12500, 13125, 13750, 14375, 15000]
     default: 10000
 
+  ti,rmii-mode:
+    description: |
+       If present, select the RMII operation mode. Two modes are
+       available:
+         - RMII master, where the PHY operates from a 25MHz clock reference,
+         provided by a crystal or a CMOS-level oscillator
+         - RMII slave, where the PHY operates from a 50MHz clock reference,
+         provided by a CMOS-level oscillator
+       The RMII operation mode can also be configured by its straps.
+       If the strap pin is not set correctly or not set at all, then this can be
+       used to configure it.
+    $ref: /schemas/types.yaml#/definitions/string
+    enum:
+      - master
+      - slave
+
 required:
   - reg
 
-- 
2.34.1