Re: [PATCH] phy: qcom-snps: Fixed order of enabling regulators

[Dmitry Baryshkov]

On Wed, 21 Feb 2024 at 12:32, Krishna Kurapati
<quic_kriskura@xxxxxxxxxxx> wrote:
>
> The SNPS Femto phy has 3 supplies, vdda-pll (0.88V), vdd18 (1.8V),
> vdd33 (3.3V). The driver enables these in order of 0.88 -> 3.3 -> 1.88.
> But on phy instances which have EUD attached, it is seen that not enabling
> the regulators in the order of (0.88 -> 1.8V -> 3.3V) is causing the EUD to
> reset the phy (issue seen rarely) thereby disturbing enumeration.
>
> This change doesn't disturb operation of phy's where EUD is not present.
> According to the some of the applicable power-supply ramp scenarios present
> in data book: (DVDD is 0.88V, VDDH is 1.8V)
>
> a) VDDH<#> and VDD33<#> held to 0 V (cannot be left floating) with DVDD
> ramped to a valid level
> b) VDD33<#> held to 0 V (cannot be left floating) with DVDD and VDDH<#>
> ramped to their respective, valid levels
>
> Modify the driver to power up the phy regulators in order of:
> 0.88 -> 1.8 -> 3.3 respectively.
>
> Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
> ---
>
> Downstream kernels on QC targets use this sequence to power up
> the phy and this has been tested extensively on multiple targets.
> This change has been tested with upstream kernel on QCM6490-IDP
> without EUD to ensure there is no loss or breakage of functionality.
>
>  drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c b/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
> index eb0b0f61d98e..e86d221b7397 100644
> --- a/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
> +++ b/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
> @@ -79,7 +79,7 @@
>  #define LS_FS_OUTPUT_IMPEDANCE_MASK            GENMASK(3, 0)
>
>  static const char * const qcom_snps_hsphy_vreg_names[] = {
> -       "vdda-pll", "vdda33", "vdda18",
> +       "vdda-pll", "vdda18", "vdda33",

NAK.
The driver uses regulator_bulk_enable, which enables all three
regulators simultaneously via async calls, thus your change doesn't
have any effect.

Also note, that these regulators are frequently shared between
different consumers. As such, even if you have tight control of
regulator ordering in the driver, other drivers might enable
corresponding regulators on their own, breaking the ordering.

-- 
With best wishes
Dmitry