[PATCH 2/2] binfmt_elf: Leave a gap between .bss and brk

[Kees Cook]

Currently the brk starts its randomization immediately after .bss,
which means there is a chance that when the random offset is 0, linear
overflows from .bss can reach into the brk area. Leave at least a single
page gap between .bss and brk (when it has not already been explicitly
relocated into the mmap range).

Reported-by: y0un9n132@xxxxxxxxx
Closes: https://lore.kernel.org/linux-hardening/CA+2EKTVLvc8hDZc+2Yhwmus=dzOUG5E4gV7ayCbu0MPJTZzWkw@xxxxxxxxxxxxxx/
Signed-off-by: Kees Cook <keescook@xxxxxxxxxxxx>
---
Cc: Jiri Kosina <jikos@xxxxxxxxxx>
Cc: Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>
Cc: Alexander Viro <viro@xxxxxxxxxxxxxxxxxx>
Cc: Christian Brauner <brauner@xxxxxxxxxx>
Cc: Jan Kara <jack@xxxxxxx>
Cc: Eric Biederman <ebiederm@xxxxxxxxxxxx>
Cc: Christophe Leroy <christophe.leroy@xxxxxxxxxx>
Cc: linux-fsdevel@xxxxxxxxxxxxxxx
Cc: linux-mm@xxxxxxxxx
---
 fs/binfmt_elf.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/fs/binfmt_elf.c b/fs/binfmt_elf.c
index 5397b552fbeb..7862962f7a85 100644
--- a/fs/binfmt_elf.c
+++ b/fs/binfmt_elf.c
@@ -1262,6 +1262,9 @@ static int load_elf_binary(struct linux_binprm *bprm)
 		if (IS_ENABLED(CONFIG_ARCH_HAS_ELF_RANDOMIZE) &&
 		    elf_ex->e_type == ET_DYN && !interpreter) {
 			mm->brk = mm->start_brk = ELF_ET_DYN_BASE;
+		} else {
+			/* Otherwise leave a gap between .bss and brk. */
+			mm->brk = mm->start_brk = mm->brk + PAGE_SIZE;
 		}
 
 		mm->brk = mm->start_brk = arch_randomize_brk(mm);
-- 
2.34.1