Re: [PATCH] tty: hvc: Don't enable the RISC-V SBI console by default

From: Anup Patel
Date: Wed Feb 14 2024 - 10:50:31 EST


On Wed, Feb 14, 2024 at 9:06 PM Palmer Dabbelt <palmer@xxxxxxxxxxxx> wrote:
>
> From: Palmer Dabbelt <palmer@xxxxxxxxxxxx>
>
> The new SBI console has the same problem as the old one: there's only
> one shared backing hardware and no synchronization, so the two drivers
> end up stepping on each other. This was the same issue the old SBI-0.1
> console drivers had, but that was disabled by default when SBI-0.1 was.
>
> So just mark the new driver as nonportable.
>
> Reported-by: Emil Renner Berthing <kernel@xxxxxxxx>
> Fixes: 88ead68e764c ("tty: Add SBI debug console support to HVC SBI driver")
> Signed-off-by: Palmer Dabbelt <palmer@xxxxxxxxxxxx>

LTGM.

Reviewed-by: Anup Patel <anup@xxxxxxxxxxxxxx>

Regards,
Anup

> ---
> drivers/tty/hvc/Kconfig | 8 +++++---
> 1 file changed, 5 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/tty/hvc/Kconfig b/drivers/tty/hvc/Kconfig
> index 6e05c5c7bca1..c2a4e88b328f 100644
> --- a/drivers/tty/hvc/Kconfig
> +++ b/drivers/tty/hvc/Kconfig
> @@ -108,13 +108,15 @@ config HVC_DCC_SERIALIZE_SMP
>
> config HVC_RISCV_SBI
> bool "RISC-V SBI console support"
> - depends on RISCV_SBI
> + depends on RISCV_SBI && NONPORTABLE
> select HVC_DRIVER
> help
> This enables support for console output via RISC-V SBI calls, which
> - is normally used only during boot to output printk.
> + is normally used only during boot to output printk. This driver
> + conflicts with real console drivers and should not be enabled on
> + systems that directly access the console.
>
> - If you don't know what do to here, say Y.
> + If you don't know what do to here, say N.
>
> config HVCS
> tristate "IBM Hypervisor Virtual Console Server support"
> --
> 2.43.0
>
>