Re: Re: [PATCH 2/3] arm64: dts: qcom: sa8295p: Enable tertiary controller and its 4 USB ports

[Bjorn Andersson]

On Tue, Feb 06, 2024 at 03:24:45PM +0200, Dmitry Baryshkov wrote:
> On Tue, 6 Feb 2024 at 14:28, Krishna Kurapati PSSNV
> <quic_kriskura@xxxxxxxxxxx> wrote:
> >
> >
> >
> > On 2/6/2024 5:43 PM, Dmitry Baryshkov wrote:
> > > On Tue, 6 Feb 2024 at 14:03, Krishna Kurapati <quic_kriskura@xxxxxxxxxxx> wrote:
> > >>
> > >> Enable tertiary controller for SA8295P (based on SC8280XP).
> > >> Add pinctrl support for usb ports to provide VBUS to connected peripherals.
> > >
> > > These are not just pinctrl entries. They hide VBUS regulators. Please
> > > implement them properly as corresponding vbus regulators.
> > >
> >
> > Hi Dmitry. Apologies, can you elaborate on your comment. I thought this
> > implementation was fine as Konrad reviewed it in v13 [1]. I removed his
> > RB tag as I made one change of dropping "_state" in labels.
> 
> My comment is pretty simple: if I'm not mistaken, your DT doesn't
> reflect your hardware design.
> You have actual VBUS regulators driven by these GPIO pins. Is this correct?
> If so, you should describe them properly in the device tree rather
> than describing them just as USB host's pinctrl state.
> 

This is correct, these gpios are wired to the enable-pin of a set of
regulators providing the VBUS voltage. Please, Krishna, represent them
as always-on fixed-regulators instead.

Regards,
Bjorn