Re: [PATCH 3/9] clk: samsung: gs101: add support for cmu_peric1

From: Peter Griffin
Date: Mon Jan 29 2024 - 07:56:00 EST


On Sat, 27 Jan 2024 at 00:19, André Draszik <andre.draszik@xxxxxxxxxx> wrote:
>
> CMU_PERIC1 is the clock management unit used for the peric1 block which
> is used for additional USI, I3C and PWM interfaces/busses. Add support
> for muxes, dividers and gates of cmu_peric1, except for
> CLK_GOUT_PERIC1_IP which isn't well described in the datasheet and
> which downstream also ignores (similar to cmu_peric0).
>
> Two clocks have been marked as CLK_IS_CRITICAL for the following
> reason:
> * disabling them makes it impossible to access any peric1
> registers, (including those two registers).
> * disabling gout_peric1_lhm_axi_p_peric1_i_clk sometimes has the
> additional effect of making the whole system unresponsive.
>
> The clocks marked as CLK_IGNORE_UNUSED need to be kept on until we have
> updated the respective drivers for the following reasons:
> * gout_peric1_gpio_peric1_pclk is required by the pinctrl
> configuration. With this clock disabled, reconfiguring the pins
> (for USI/I2C, USI/UART) will hang during register access.
> Since pingctrl-samsung doesn't support a clock at the moment, we
> just keep the kernel from disabling it at boot, until we have an
> update for samsung-pinctrl, at which point we'll drop the flag.
> * gout_peric1_sysreg_peric1_pclk needs to be hooked up to
> sysreg_peric1 in DT which will be done in a followup-patch, at
> which point we'll drop the special treatment from here. We're
> adding the flag temporarily here so as to not break the boot (due
> to pclk otherwise getting disabled).
>
> Signed-off-by: André Draszik <andre.draszik@xxxxxxxxxx>
>
> ---

Thankyou for being verbose on this reasoning behind CLK_IGNORE_UNUSED
and CLK_IS_CRITICAL flags

Reviewed-by: Peter Griffin <peter.griffin@xxxxxxxxxx>