[PATCH] tty: serial: 8250: Set RS232 as default for Moxa PCIe board initialization

[Crescent CY Hsieh]

After switching the serial interface of the Moxa RS232 PCIe boards, it
fails to reset to RS232 when attempting to reload 8250_pci driver.

This patch set RS232 as the default setting during the initialization of
Moxa PCIe board.

Signed-off-by: Crescent CY Hsieh <crescentcy.hsieh@xxxxxxxx>
---
 drivers/tty/serial/8250/8250_pci.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/tty/serial/8250/8250_pci.c b/drivers/tty/serial/8250/8250_pci.c
index 8ccf691935b7..0d35c77fad9e 100644
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -2039,12 +2039,13 @@ static int pci_moxa_init(struct pci_dev *dev)
 	unsigned short device = dev->device;
 	resource_size_t iobar_addr = pci_resource_start(dev, 2);
 	unsigned int num_ports = (device & 0x00F0) >> 4, i;
-	u8 val;
+	u8 val, init_mode = MOXA_RS232;
 
 	if (!(pci_moxa_supported_rs(dev) & MOXA_SUPP_RS232)) {
-		for (i = 0; i < num_ports; ++i)
-			pci_moxa_set_interface(dev, i, MOXA_RS422);
+		init_mode = MOXA_RS422;
 	}
+	for (i = 0; i < num_ports; ++i)
+		pci_moxa_set_interface(dev, i, init_mode);
 
 	/*
 	 * Enable hardware buffer to prevent break signal output when system boots up.
-- 
2.34.1