USB PD TYPEC - FUSB302B port controller hard reset issue

[Suniel Mahesh]

Hi Guenter Roeck / Heikki Krogerus and all,

1.
I am testing USB TYPEC PD on a Rockchip Rk3399 SOC based target which
has a FUSB302B TYPEC port controller.

2.
My source is a wall charger which is based on Gallium Nitride (GaN II)
technology and has four ports as follows:

USB-C1: 100W PD3.0, 5V/3A, 9V/3A, 12V/3A, 15V/3A. 20V/5A. PPS: 3.3V-11V/4A
USB-C2: 100W PD3.0. 5V/3A. 9V/3A. 12V/3A, 15V/3A. 20V/5A PPS:3.3-11V/4A
USB-C3: 20W PD3.0, 5V/3A, 9V/2.22A, 12V/1.67A
USB-A: 18W QC3.0. 5V/3A, 9V/2A, 12V/1.5A

3.
i am using latest linux-next and enabled all the relevant configs, especially:
CONFIG_TYPEC=y
CONFIG_TYPEC_TCPM=y
CONFIG_TYPEC_FUSB302=y

4.
DT node is as follows when i use USB-C1 of wall charger:

 connector {
                        compatible = "usb-c-connector";
                        label = "USB-C";
                        data-role = "dual";
                        power-role = "sink";
                        try-power-role = "sink";
                        op-sink-microwatt = <1000000>;
                        sink-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)
                                    PDO_FIXED(12000, 3000, PDO_FIXED_USB_COMM)>;
                };

Issue:
The board power well most of the time, but may be in 1 out of 5 cold
boots, FUSB302B is getting a hard reset, as
FUSB302B INTERRUPTA register bit I_HARDRST is getting set.

After some digging, found out that the above behaviour is accounted to
when something is wrong with the CRC of
the received packet (SOP - Start of Packet)

This behaviour is seen i.e. FUSB302B getting a hard reset more on the
USB-C3 port.

Any pointers on how to solve this issue.

Thanks and Regards
-- 
Suniel Mahesh
Embedded Linux and Kernel Engineer
Amarula Solutions India