[PATCH RFC v3 03/11] scsi: ufs: qcom: Perform read back after writing testbus config

[Andrew Halaney]

Currently, the testbus configuration is written and completed with an
mb().

mb() ensure that the write completes, but completion doesn't mean
that it isn't stored in a buffer somewhere. The recommendation for
ensuring this bit has taken effect on the device is to perform a read
back to force it to make it all the way to the device. This is
documented in device-io.rst and a talk by Will Deacon on this can
be seen over here:

    https://youtu.be/i6DayghhA8Q?si=MiyxB5cKJXSaoc01&t=1678

Let's do that to ensure the bit hits the device. Because the mb()'s
purpose wasn't to add extra ordering (on top of the ordering guaranteed
by writel()/readl()), it can safely be removed.

Fixes: 9c46b8676271 ("scsi: ufs-qcom: dump additional testbus registers")
Signed-off-by: Andrew Halaney <ahalaney@xxxxxxxxxx>
---
 drivers/ufs/host/ufs-qcom.c | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index 4c15c8a1d058..6df2ab3b6f23 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -1332,6 +1332,9 @@ static void ufs_qcom_enable_test_bus(struct ufs_qcom_host *host)
 	ufshcd_rmwl(host->hba, UFS_REG_TEST_BUS_EN,
 			UFS_REG_TEST_BUS_EN, REG_UFS_CFG1);
 	ufshcd_rmwl(host->hba, TEST_BUS_EN, TEST_BUS_EN, REG_UFS_CFG1);
+
+	/* dummy read to ensure this has been enabled prior to returning */
+	ufshcd_readl(host->hba, REG_UFS_CFG1);
 }
 
 static void ufs_qcom_get_default_testbus_cfg(struct ufs_qcom_host *host)
@@ -1429,11 +1432,6 @@ int ufs_qcom_testbus_config(struct ufs_qcom_host *host)
 		    (u32)host->testbus.select_minor << offset,
 		    reg);
 	ufs_qcom_enable_test_bus(host);
-	/*
-	 * Make sure the test bus configuration is
-	 * committed before returning.
-	 */
-	mb();
 
 	return 0;
 }

-- 
2.43.0