Re: [PATCH v9 3/3] gpio: nuvoton: Add Nuvoton NPCM sgpio driver

[Jim Liu]

Hi Andy

Thanks for your comments.
I will modify it in the next version.

But some description as below



> > +static int npcm_sgpio_init_port(struct npcm_sgpio *gpio)
> > +{
> > +     u8 in_port, out_port, set_port, reg;
> > +
> > +     in_port = GPIO_BANK(gpio->nin_sgpio);
> > +     if (GPIO_BIT(gpio->nin_sgpio) > 0)
> > +             in_port += 1;
>
> This is strange... So, you are telling that offsets start from 1 and not 0?
>
> > +     out_port = GPIO_BANK(gpio->nout_sgpio);
> > +     if (GPIO_BIT(gpio->nout_sgpio) > 0)
> > +             out_port += 1;
>
> Ditto.
>
Yes,  if the customer has defined the in/out pins the offsets start from 1.
The NPCM_IOXCFG2_PORT register is the set number of in/out ports.
NPCM_IOXCFG2_PORT register define as below:
0~3 bit is the number of input ports
4~7 bit is the number of output ports
Each module can support 8 input ports and 8 output ports.
> ...
>
> > +     set_port = ((out_port & NPCM_IOXCFG2_PORT) << 4) | (in_port & NPCM_IOXCFG2_PORT);
>
> Outer parentheses are redundant.
>
> ...
>

Best regards,
Jim