Re: [PATCH 10/13] arm64: dts: exynos: gs101: define USI8 with I2C configuration

[Krzysztof Kozlowski]

On 14/12/2023 11:52, Tudor Ambarus wrote:
> USI8 I2C is used to communicate with an eeprom found on the battery
> connector. Define USI8 in I2C configuration.
> 
> USI8 CONFIG register comes with a 0x0 reset value, meaning that USI8
> doesn't have a default protocol (I2C, SPI, UART) at reset. Thus the
> selection of the protocol is intentionally left for the board dtsi file.
> 
> Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/exynos/google/gs101.dtsi | 26 ++++++++++++++++++++
>  1 file changed, 26 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/exynos/google/gs101.dtsi b/arch/arm64/boot/dts/exynos/google/gs101.dtsi
> index ffb7b4d89a8c..4ea1b180cd0a 100644
> --- a/arch/arm64/boot/dts/exynos/google/gs101.dtsi
> +++ b/arch/arm64/boot/dts/exynos/google/gs101.dtsi
> @@ -354,6 +354,32 @@ pinctrl_peric0: pinctrl@10840000 {
>  			interrupts = <GIC_SPI 625 IRQ_TYPE_LEVEL_HIGH 0>;
>  		};
>  
> +		usi8: usi@109700c0 {
> +			compatible = "google,gs101-usi",
> +				     "samsung,exynos850-usi";
> +			reg = <0x109700c0 0x20>;
> +			ranges;
> +			#address-cells = <1>;
> +			#size-cells = <1>;
> +			clocks = <&cmu_peric0 CLK_DOUT_PERIC0_USI8_USI>,
> +				 <&cmu_peric0 CLK_GOUT_PERIC0_CLK_PERIC0_USI8_USI_CLK>;
> +			clock-names = "pclk", "ipclk";
> +			samsung,sysreg = <&sysreg_peric0 0x101c>;
> +			status = "disabled";
> +
> +			hsi2c_8: i2c@10970000 {
> +				compatible = "google,gs101-hsi2c",
> +					     "samsung,exynosautov9-hsi2c";
> +				reg = <0x10970000 0xc0>;
> +				interrupts = <GIC_SPI 642
> +					      IRQ_TYPE_LEVEL_HIGH 0>;

This can be in one line. Limit of 80 is not a hard-limit. It can be
violated if it improves readability. Especially if is about 1 character
only.



Best regards,
Krzysztof