Re: [PATCH 0/7] Minor cleanup for thermal gov power allocator

[Rafael J. Wysocki]

On Fri, Nov 24, 2023 at 8:44 AM Lukasz Luba <lukasz.luba@xxxxxxx> wrote:
>
>
>
> On 11/23/23 19:50, Rafael J. Wysocki wrote:
> > Hi Lukasz,
> >
> > On Thu, Nov 23, 2023 at 4:19 PM Lukasz Luba <lukasz.luba@xxxxxxx> wrote:
> >>
> >> Hi Rafael,
> >>
> >> Gentle ping
> >>
> >> On 10/26/23 13:22, Lukasz Luba wrote:
> >>>
> >>>
> >>> On 10/26/23 09:54, Rafael J. Wysocki wrote:
> >>>> On Wed, Oct 25, 2023 at 9:21 PM Lukasz Luba <lukasz.luba@xxxxxxx> wrote:
> >>>>>
> >>>>> Hi all,
> >>>>>
> >>>>> The patch set does some small clean up for Intelligent Power Allocator.
> >>>>> Those changes are not expected to alter the general functionality.
> >>>>> They just
> >>>>> improve the code reading. Only patch 3/7 might improve the use case for
> >>>>> binding the governor to thermal zone (very unlikely in real products,
> >>>>> but
> >>>>> it's needed for correctness).
> >>>>>
> >>>>> The changes are based on top of current PM thermal branch, so with the
> >>>>> new trip points.
> >>>>>
> >>>>> Regards,
> >>>>> Lukasz
> >>>>>
> >>>>> Lukasz Luba (7):
> >>>>>     thermal: gov_power_allocator: Rename trip_max_desired_temperature
> >>>>>     thermal: gov_power_allocator: Setup trip points earlier
> >>>>>     thermal: gov_power_allocator: Check the cooling devices only for
> >>>>>       trip_max
> >>>>>     thermal: gov_power_allocator: Rearrange the order of variables
> >>>>>     thermal: gov_power_allocator: Use shorter variable when possible
> >>>>>     thermal: gov_power_allocator: Remove unneeded local variables
> >>>>>     thermal: gov_power_allocator: Clean needed variables at the beginning
> >>>>>
> >>>>>    drivers/thermal/gov_power_allocator.c | 123 ++++++++++++++------------
> >>>>>    1 file changed, 64 insertions(+), 59 deletions(-)
> >>>>>
> >>>>> --
> >>>>
> >>>> The series looks good to me overall, but I'd prefer to make these
> >>>> changes in the 6.8 cycle, because the 6.7 merge window is around the
> >>>> corner and there is quite a bit of thermal material in this cycle
> >>>> already.
> >>>
> >>> Thanks for having a look! Yes, I agree, we can wait after the
> >>> merge window. It just have to be cleaned one day a bit and I postponed
> >>> this a few times, so no rush ;)
> >>
> >> I've seen you've created the new pm/thermal. Could you consider to take
> >> those in, please?
> >
> > Sure, I'll get to them presumably tomorrow and if not then early next week.
>
> OK, thank you Rafael!

I've queued up the whole lot for 6.8 and in the process I've edited
all of the changelogs and some subjects for clarity and English
grammar improvements.

Thanks!