Re: [PATCH v2 3/4] arm64: dts: nuvoton: Add pinctrl support for ma35d1

From: Krzysztof Kozlowski
Date: Tue Nov 28 2023 - 06:06:36 EST


On 28/11/2023 11:45, Jacky Huang wrote:
> Dear Krzysztof,
>
> Thanks for your review.
>
> On 2023/11/28 下午 05:34, Krzysztof Kozlowski wrote:
>> On 28/11/2023 09:37, Jacky Huang wrote:
>>>>> + gpion: gpio@40040340 {
>>>>> + reg = <0x340 0x40>;
>>>>> + interrupts = <GIC_SPI 105 IRQ_TYPE_LEVEL_HIGH>;
>>>>> + clocks = <&clk GPN_GATE>;
>>>>> + gpio-controller;
>>>>> + #gpio-cells = <2>;
>>>>> + interrupt-controller;
>>>>> + #interrupt-cells = <2>;
>>>>> + };
>>>>> +
>>>>> + pcfg_default: pin-default {
>>>>> + slew-rate = <0>;
>>>>> + input-schmitt-disable;
>>>>> + bias-disable;
>>>>> + power-source = <1>;
>>>>> + drive-strength = <17100>;
>>>>> + };
>>>> It does not look like you tested the DTS against bindings. Please run
>>>> `make dtbs_check W=1` (see
>>>> Documentation/devicetree/bindings/writing-schema.rst or
>>>> https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
>>>> for instructions).
>>>>
>>>> Best regards,
>>>> Krzysztof
>>>>
>>> I forgot to remove 'ma35d1-pinfunc.h' from my local copy.
>>> After remove the '#include <dt-bindings/pinctrl/ma35d1-pinfunc.h>', it
>>> can pass
>>> the `make dtbs_check W=1` check.
>>> I will fix it in the next version.
>> Really? Then your bindings look wrong. Why do you mix MMIO nodes and
>> non-MMIO in one device node?
>>
>> Best regards,
>> Krzysztof
>>
>
> Yes, it did pass the 'dtbs_check'. I guess the tool does not detect such
> issues.
> Anyway, I will fix it in the next version.

Hm, I see your bindings indeed allow pin-.* and unit addresses, so it is
the binding issue.

The examples you used as reference - xlnx,zynqmp-pinctrl.yaml and
realtek,rtd1315e-pinctrl.yaml - do not mix these as you do.

I don't understand why do you need them yet. I don't see any populate of
children. There are no compatibles, either.

Which part of your driver uses them exactly?

Best regards,
Krzysztof