Re: [PATCH v2 12/12] [UNTESTED] riscv: dts: starfive: beaglev-starlight: Enable gmac

[Emil Renner Berthing]

Cristian Ciocaltea wrote:
> The BeagleV Starlight SBC uses a Microchip KSZ9031RNXCA PHY supporting
> RGMII-ID.
>
> TODO: Verify if manual adjustment of the RX internal delay is needed. If
> yes, add the mdio & phy sub-nodes.

Sorry for being late here. I've tested that removing the mdio and phy nodes on
the the Starlight board works fine, but the rx-internal-delay-ps = <900>
property not needed on any of my VisionFive V1 boards either. So I wonder why
you need that on your board

Also in the driver patch you add support for phy-mode = "rgmii-txid", but here
you still set it to "rgmii-id", so which is it?

You've alse removed the phy reset gpio on the Starlight board:

  snps,reset-gpios = <&gpio 63 GPIO_ACTIVE_LOW>

Why?

>
> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxxxxxx>
> ---
>  arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts | 5 +++++
>  1 file changed, 5 insertions(+)
>
> diff --git a/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts b/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts
> index 7cda3a89020a..d3f4c99d98da 100644
> --- a/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts
> +++ b/arch/riscv/boot/dts/starfive/jh7100-beaglev-starlight.dts
> @@ -11,3 +11,8 @@ / {
>  	model = "BeagleV Starlight Beta";
>  	compatible = "beagle,beaglev-starlight-jh7100-r0", "starfive,jh7100";
>  };
> +
> +&gmac {
> +	phy-mode = "rgmii-id";
> +	status = "okay";
> +};

Lastly the phy-mode and status are the same for the VF1 and Starlight boards,
so why can't these be set in the jh7100-common.dtsi?

/Emil

> --
> 2.42.0
>