Re: [PATCH] mmc: Fix force card detect in sdhci

[Mathieu Moneyron]

On Fri, Nov 10, 2023 at 8:57 PM Aubin Constans
<aubin.constans@xxxxxxxxxxxxx> wrote:
>
> On 23/09/2023 16:23, Mathieu Moneyron wrote:
>
> In the device tree, has PIN_PA13__SDMMC0_CD been removed from the
> pinctrl for sdmmc0?
Yes the pin is not present in the pinctrl. Only PA0 to PA10 configured as
SDMMC0 function.
>
> In case the above behaviour was due to hardware, it would likely point
> out a flaw in the Parallel Input/Output Controller (PIO) rather than in
> the SDMMC Controller.
>
> Would you read back the relevant PIO_CFGRx register, with only "PA13"
> set in PIO_MSKRx, and provide me with the value read?
> Assuming PA13 is Non-Secure; if PA13 is configured as Secure,
> S_PIO_CFGRx and S_PIO_MSKRx should be accessed instead.
I'm not sure if that's the best way to achieve this but I enabled debug
messages in pinctrl-at91-pio4 driver.
The messages I got regarding the PA13 pin is the following:
'enable pin 13 as GPIO'
With PIO_CFGR0 register for PA13 only is 0x0400.

Also from PA0 to PA10 the pins used for the in the mmc pinctrl:
'enable function A group PA0'
For all these pins funcion A is SDMMC0.

Also as a side note, I will no longer have access to the hardware from the
beginning of december as I have resigned from my current job.

Best regards,
Mathieu