Re: [PATCH net 1/1] net: stmmac: fix MAC and phylink mismatch issue after resume with STMMAC_FLAG_USE_PHY_WOL enabled

[Paolo Abeni]

On Thu, 2023-11-09 at 09:15 +0000, Russell King (Oracle) wrote:
> On Thu, Nov 09, 2023 at 01:00:27PM +0800, Gan Yi Fang wrote:
> > From: "Gan, Yi Fang" <yi.fang.gan@xxxxxxxxx>
> > 
> > The issue happened when flag STMMAC_FLAG_USE_PHY_WOL is enabled.
> > It can be reproduced with steps below:
> > 1. Advertise only one speed on the host
> > 2. Enable the WoL on the host
> > 3. Suspend the host
> > 4. Wake up the host
> > 
> > When the WoL is disabled, both the PHY and MAC will suspend and wake up
> > with everything configured well. When WoL is enabled, the PHY needs to be
> > stay awake to receive the signal from remote client but MAC will enter
> > suspend mode.
> > 
> > When the MAC resumes from suspend, phylink_resume() will call
> > phylink_start() to start the phylink instance which will trigger the
> > phylink machine to invoke the mac_link_up callback function. The
> > stmmac_mac_link_up() will configure the MAC_CTRL_REG based on the current
> > link state. Then the stmmac_hw_setup() will be called to configure the MAC.
> > 
> > This sequence might cause mismatch of the link state between MAC and
> > phylink. This patch moves the phylink_resume() after stmamc_hw_setup() to
> > ensure the MAC is initialized before phylink is being configured.
> 
> Isn't this going to cause problems?
> 
> stmamc_hw_setup() calls stmmac_init_dma_engine(), which then calls
> stmmac_reset() - and stmmac_reset() can fail if the PHY clock isn't
> running, which is why phylink_resume() gets called before this.

@Gan Yi Fang: at very least we need a solid explanation in the commit
message why this change don't cause the above problems.

Thanks,

Paolo