Re: [PATCH v2 4/7] scsi: ufs: ufs-qcom: Limit HS-G5 Rate-A to hosts with HW version 5

[Can Guo]

Hi Mani,

On 11/8/2023 1:25 PM, Manivannan Sadhasivam wrote:
> On Mon, Nov 06, 2023 at 08:46:10PM -0800, Can Guo wrote:
> > From: Can Guo <quic_cang@xxxxxxxxxxx>
> >
> > Qcom UFS hosts, with HW ver 5, can only support up to HS-G5 Rate-A due to
> > HW limitations. If the HS-G5 PHY gear is used, update host_params->hs_rate
> > to Rate-A, so that the subsequent power mode changes shall stick to Rate-A.
> >
> > Signed-off-by: Can Guo <quic_cang@xxxxxxxxxxx>
> > ---
> >   drivers/ufs/host/ufs-qcom.c | 18 +++++++++++++++++-
> >   1 file changed, 17 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
> > index 60b35ca..55ee31d 100644
> > --- a/drivers/ufs/host/ufs-qcom.c
> > +++ b/drivers/ufs/host/ufs-qcom.c
> > @@ -442,9 +442,25 @@ static u32 ufs_qcom_get_hs_gear(struct ufs_hba *hba)
> >   static int ufs_qcom_power_up_sequence(struct ufs_hba *hba)
> >   {
> >   	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
> > +	struct ufs_host_params *host_params = &host->host_params;
> >   	struct phy *phy = host->generic_phy;
> > +	enum phy_mode mode;
> >   	int ret;
> >   
> > +	/*
> > +	 * HW ver 5 can only support up to HS-G5 Rate-A due to HW limitations.
>
> Does this limitation apply to future targets as well or just to SM8550? If
> it's the latter, then we need to use a flag.
>
> - ManiUFS host controller HW ver (major) 5 IPs (they may have different 
minor/step verions) can be used by many QCOM chipsets, so it applies to 
several available targets and future targets which are going to have HW 
ver 5 UFS host controller. This limitation goes away since HW ver 6.

Thanks,
Can Guo.