Re: [PATCH 2/3] clk: qcom: ipq6018: add USB GDSCs

[Konrad Dybcio]

On 10/31/23 10:01, Robert Marko wrote:
> On Mon, 30 Oct 2023 at 22:12, Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> wrote:
> > On 30.10.2023 21:37, Robert Marko wrote:
> > > On Mon, 30 Oct 2023 at 20:37, Konrad Dybcio <konrad.dybcio@xxxxxxxxxx> wrote:
> > > > On 29.10.2023 12:04, Robert Marko wrote:
> > > > > On Wed, 25 Oct 2023 at 12:45, Robert Marko <robimarko@xxxxxxxxx> wrote:
> > > > > > IPQ6018 has GDSC-s for each of the USB ports, so lets define them as such
> > > > > > and drop the curent code that is de-asserting the USB GDSC-s as part of
> > > > > > the GCC probe.
> > > > > >
> > > > > > Signed-off-by: Robert Marko <robimarko@xxxxxxxxx>
> > > > >
> > > > > Unfortunately, after testing on multiple devices I hit the same GDSC
> > > > > issue I had a long time ago
> > > > > that was the reason I did not send this upstream.
> > > > > It seems that USB3 port GDSC (USB0 GDSC in code) works just fine,
> > > > > however the USB2 one
> > > > > (USB1 GDSC in code) it is stuck off and USB2 port will fail due to this:
> > > > >      1.607531] ------------[ cut here ]------------
> > > > > [    1.607559] usb1_gdsc status stuck at 'off'
> > > > > [    1.607592] WARNING: CPU: 0 PID: 35 at gdsc_toggle_logic+0x16c/0x174
> > > > > [    1.615120] Modules linked in:
> > > > Can you dump GDSCR (the entire 32-bit register) at boot and when toggling?
> > >
> > > Sure, here it is:
> > > [    0.023760] qcom,gcc-ipq6018 1800000.gcc: reg: 0x3e078 val: 0x8222004 init
> > > [    0.023782] qcom,gcc-ipq6018 1800000.gcc: reg: 0x3f078 val: 0x8222004 init
> > > [    0.988626] qcom,gcc-ipq6018 1800000.gcc: reg: 0x3f078 val:
> > > 0x8282000 before toggle
> > > [    1.202506] qcom,gcc-ipq6018 1800000.gcc: reg: 0x3f078 val:
> > > 0x8282000 after toggle
> > > [    1.207208] qcom,gcc-ipq6018 1800000.gcc: reg: 0x3e078 val:
> > > 0xa0282000 before toggle
> > Any chance
> >
> > .en_few_wait_val = 0x2
> >
> > (turning BIT(19) into BIT(17))
> >
> > will make a difference?
>
> Sadly, it makes no difference and GDSC status bit newer comes up which is
> rather weird as USB0 one seems to work just fine.
What if you add clk_ignore_unused?

Konrad