Re: [PATCH v3 1/8] clk: qcom: clk-alpha-pll: introduce stromer plus ops

[Stephen Boyd]

Quoting Varadarajan Narayanan (2023-10-18 02:29:14)
> diff --git a/drivers/clk/qcom/clk-alpha-pll.c b/drivers/clk/qcom/clk-alpha-pll.c
> index 4edbf77..f839a31 100644
> --- a/drivers/clk/qcom/clk-alpha-pll.c
> +++ b/drivers/clk/qcom/clk-alpha-pll.c
> @@ -2508,3 +2508,60 @@ const struct clk_ops clk_alpha_pll_stromer_ops = {
>         .set_rate = clk_alpha_pll_stromer_set_rate,
>  };
>  EXPORT_SYMBOL_GPL(clk_alpha_pll_stromer_ops);
> +
> +static int clk_alpha_pll_stromer_plus_set_rate(struct clk_hw *hw,
> +                                              unsigned long rate,
> +                                              unsigned long prate)
> +{
> +       struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
> +       u32 l, alpha_width = pll_alpha_width(pll);
> +       int ret;
> +       u64 a;
> +
> +       rate = alpha_pll_round_rate(rate, prate, &l, &a, alpha_width);
> +
> +       regmap_write(pll->clkr.regmap, PLL_MODE(pll), 0);

It still assumes the clk is always enabled. Please read back the
register value and make sure the PLL was already enabled before
restoring the enable state of the clk.

> +
> +       /* Delay of 2 output clock ticks required until output is disabled */
> +       udelay(1);