Re: [PATCH v2 18/28] pinctrl: renesas: rzg2l: add support for different ds values on different groups

[claudiu beznea]

On 04.10.2023 16:17, Geert Uytterhoeven wrote:
> On Fri, Sep 29, 2023 at 7:39 AM Claudiu <claudiu.beznea@xxxxxxxxx> wrote:
>> From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>
>>
>> RZ/G3S supports different drive strength values for different power sources
>> and pin groups (A, B, C). On each group there could be up to 4 drive
>> strength values per power source. Available power sources are 1v8, 2v5,
>> 3v3. Drive strength values are fine tuned than what was previously
>> available on the driver thus the necessity of having micro-amp support.
>> As drive strength and power source values are linked together the
>> hardware setup for these was moved at the end of
>> rzg2l_pinctrl_pinconf_set() to ensure proper validation of the new
>> values.
>>
>> The drive strength values are expected to be initialized though SoC
>> specific hardware configuration data structure.
>>
>> Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>
>> ---
>>
>> Changes in v2:
>> - s/strenght/strength, s/togheter/together in commit description
>> - got rid of RZG2L_INVALID_IOLH_VAL macro and consider zero as invalid
>>   value for entries in struct rzg2l_hwcfg::iolh_group[abc]_ua[] arrays
>> - removed spinlock in rzg2l_[sg]et_power_source()
>> - introduced caps_to_pwr_reg() and simplified the code in
>>   rzg2l_[sg]et_power_source()
>> - changed return type of rzg2l_iolh_ua_to_val() to int and return
>>   -EINVAL on failure cases
>> - s/rzg2l_ds_supported/rzg2l_ds_is_supported
>> - inverted the logic in rzg2l_pinctrl_pinconf_set() when applying drive
>>   strength and power source to hardware registers and thus simplified the
>>   code
>> - used devm_kcalloc() instead of devm_kzalloc()
>> - adderessed the rest of the review comments
> 
> Thanks, will queue in renesas-pinctrl-for-v6.7, with Paul's comment
> addresses.

Thank you Geert and Paul!

> 
> Gr{oetje,eeting}s,
> 
>                         Geert
>