Re: [PATCH v3 1/2] dt-bindings: PCI: mediatek-gen3: Add support for controlling power and reset

[Rob Herring]

On Thu, Sep 28, 2023 at 06:58:20PM +0800, Jian Yang wrote:
> From: "jian.yang" <jian.yang@xxxxxxxxxxxx>
> 
> Add new properties to support control power supplies and reset pin of
> a downstream component.
> 
> Signed-off-by: jian.yang <jian.yang@xxxxxxxxxxxx>
> ---
>  .../bindings/pci/mediatek-pcie-gen3.yaml      | 25 +++++++++++++++++++
>  1 file changed, 25 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/pci/mediatek-pcie-gen3.yaml b/Documentation/devicetree/bindings/pci/mediatek-pcie-gen3.yaml
> index 7e8c7a2a5f9b..32031362db58 100644
> --- a/Documentation/devicetree/bindings/pci/mediatek-pcie-gen3.yaml
> +++ b/Documentation/devicetree/bindings/pci/mediatek-pcie-gen3.yaml
> @@ -84,6 +84,26 @@ properties:
>      items:
>        enum: [ phy, mac ]
>  
> +  pcie1v8-supply:
> +    description:
> +      The regulator phandle that provides 1.8V power from root port to a
> +      downstream component.
> +
> +  pcie3v3-supply:
> +    description:
> +      The regulator phandle that provides 3.3V power from root port to a
> +      downstream component.
> +
> +  pcie12v-supply:
> +    description:
> +      The regulator phandle that provides 12V power from root port to a
> +      downstream component.
> +
> +  dsc-reset-gpios:

This should be in the downstream component if it is something extra. So 
not the root port node, but the next one down. 

> +    description:
> +      The extra reset pin other than PERST# required by a downstream component.
> +    maxItems: 1
> +
>    clocks:
>      minItems: 4
>      maxItems: 6
> @@ -238,5 +258,10 @@ examples:
>                        #interrupt-cells = <1>;
>                        interrupt-controller;
>              };
> +
> +            pcie@0 {

Missing 'reg'.

> +              device_type = "pci";
> +              pcie-3v3-supply = <&pcie3v3_regulator>;

This is in the root port (which is good), but you've defined the schema 
to put them in the host bridge node. IOW, these need to go in a PCI 
root-port or P2P bridge schema which doesn't yet exist. I have an 
inprogress branch for dtschema to split up pci-bus.yaml for that 
purpose. Will try to finish it up soon.

Rob