Re: [PATCH v2] irqchip/qcom-pdc: add support for v3.2 HW

[Maulik Shah (mkshah)]

Hi,

On 8/23/2023 1:16 PM, Neil Armstrong wrote:
> Hi,
>
> On 23/08/2023 07:35, Maulik Shah (mkshah) wrote:
> > Hi Neil,
> >
> > @@ -142,8 +163,17 @@ static int qcom_pdc_gic_set_type(struct irq_data 
> > *d, unsigned int type)
> > >           return -EINVAL;
> > >       }
> > > -    old_pdc_type = pdc_reg_read(IRQ_i_CFG, d->hwirq);
> > > -    pdc_reg_write(IRQ_i_CFG, d->hwirq, pdc_type);
> > > +    if (pdc_version < PDC_VERSION_3_2) {
> > > +        old_pdc_type = pdc_reg_read(IRQ_i_CFG, d->hwirq);
> > > +        pdc_reg_write(IRQ_i_CFG, d->hwirq, pdc_type);
> > > +    } else {
> > > +        u32 val;
> > > +
> > > +        val = pdc_reg_read(IRQ_i_CFG, d->hwirq);
> > > +        old_pdc_type = val & IRQ_i_CFG_TYPE_MASK;
> > > +        pdc_reg_write(IRQ_i_CFG, d->hwirq,
> > > +                  pdc_type | (val & IRQ_i_CFG_IRQ_ENABLE));
> > > +    }
> > While above is correct, i don't think we need version check in 
> > qcom_pdc_gic_set_type() as bits 0-2 are always for the type in 
> > old/new version as mentioned in v1.
> >
> > Adding one line after reading old_pdc_type should be good enough.
>
> Yes I understood, but while looking at the IRQ_i_CFG bits, I wanted to 
> keep the original
> driver behavior intact by setting remaining bits to 0.
>
> Adding this single line changes that behavior and keeps bits 3-31
> to the default register value, which may have some consequences.
>
> If you consider it's an ok change, then I'll reduce it to this single 
> line.
Yes this ok change to have single line and should not have  any 
consequences.

Thanks,
Maulik