Re: Infiniate systemd loop when power off the machine with multiple MD RAIDs

From: Yu Kuai
Date: Tue Aug 22 2023 - 21:28:35 EST


Hi,

在 2023/08/23 3:13, Carlos Carvalho 写道:
Song Liu (song@xxxxxxxxxx) wrote on Tue, Aug 22, 2023 at 03:56:04PM -03:
>From systemd code, i.e. function delete_md(), this error:

[ 205.957004] systemd-shutdown[1]: Stopping MD /dev/md124p1 (259:6).
[ 205.964177] systemd-shutdown[1]: Could not stop MD /dev/md124p1:
Device or resource busy

is most likely triggered by ioctl(STOP_ARRAY).

And based on the code, I think the ioctl fails here:

if (cmd == STOP_ARRAY || cmd == STOP_ARRAY_RO) {
/* Need to flush page cache, and ensure no-one else opens
* and writes
*/
mutex_lock(&mddev->open_mutex);
if (mddev->pers && atomic_read(&mddev->openers) > 1) {
mutex_unlock(&mddev->open_mutex);
err = -EBUSY;
goto out; ////////////////////// HERE

Yes, I suspect here as well, but I do some test with error injection to
gurantee that ioctl(STOP_ARRAY) always return -EBUSY, but I found that
system reboot didn't hang, it'll try a few times but eventually reboot
finished.

}
if (test_and_set_bit(MD_CLOSING, &mddev->flags)) {
mutex_unlock(&mddev->open_mutex);
err = -EBUSY;
goto out;
}
did_set_md_closing = true;
mutex_unlock(&mddev->open_mutex);
sync_blockdev(bdev);
}

Probably. The problem is why doesn't it manage to flush the page cache? I find
strange that the problem appears only when trying to stop the array, I get it
when trying to umount the filesystem, where it also hangs because of the same
reason. The kworker thread runs continuously using 100% cpu of only 1 core.

The kworker do you mean the daemon thread or the sync thread? runs
continuously using 100% cpu doen't sounds correct to me.

Thanks,
Kuai


These are all similar symptoms of the underlying problem which I complained
about days ago: the system doesn't manage to write to the disks, which stay
nearly idle. If you wait long enough without issuing writes, which can be
several hours, it'll eventually flush the page cache and proceed to a "normal"
umount or reboot.

The bug is dependent on the rate of writes and also on uptime; it rarely
appears soon after boot, and increases as times passes.

.