Re: [PATCH v6 3/6] iio: adc: mcp3911: simplify usage of spi->dev

[Andy Shevchenko]

On Thu, Aug 17, 2023 at 02:05:15PM +0200, Marcus Folkesson wrote:
> Replace the usage of `adc->spi->dev` with `dev` to make the code prettier.

...

> @@ -277,9 +278,7 @@ static int mcp3911_calc_scale_table(struct mcp3911 *adc)

>  		ret = regulator_get_voltage(adc->vref);
>  		if (ret < 0) {
> -			dev_err(&adc->spi->dev,
> -				"failed to get vref voltage: %d\n",
> -			       ret);
> +			dev_err(dev, "failed to get vref voltage: %d\n", ret);

So, this can be part of the previous patch as this function is the part of the
->probe() stage.

>  			return ret;
>  		}

...

> @@ -396,12 +395,10 @@ static int mcp3911_config(struct mcp3911 *adc)
>  	if (ret)
>  		device_property_read_u32(dev, "device-addr", &adc->dev_addr);
>  	if (adc->dev_addr > 3) {
> -		dev_err(&adc->spi->dev,
> -			"invalid device address (%i). Must be in range 0-3.\n",
> -			adc->dev_addr);
> +		dev_err(dev, "invalid device address (%i). Must be in range 0-3.\n", adc->dev_addr);
>  		return -EINVAL;

Ditto.

>  	}

...

> +		adc->trig = devm_iio_trigger_alloc(dev, "%s-dev%d",
> +						   indio_dev->name,
> +						   iio_device_id(indio_dev));

Seem you already switched to longer lines, hence this can be compressed
to two lines.

>  		if (!adc->trig)
>  			return -ENOMEM;

...

> +		ret = devm_request_irq(dev, spi->irq,
> +				       &iio_trigger_generic_data_rdy_poll,

In the similar way as above.

> +				       IRQF_NO_AUTOEN | IRQF_ONESHOT,
> +				       indio_dev->name, adc->trig);
>  		if (ret)
>  			return ret;


-- 
With Best Regards,
Andy Shevchenko