Re: [PATCH v2 2/4] riscv: dts: allwinner: d1: Add CAN controller nodes

[Jernej Škrabec]

Dne nedelja, 23. julij 2023 ob 11:18:33 CEST je John Watts napisal(a):
> On Sat, Jul 22, 2023 at 08:15:51AM +1000, John Watts wrote:
> > ...
> > +			/omit-if-no-ref/
> > +			can0_pins: can0-pins {
> > +				pins = "PB2", "PB3";
> > +				function = "can0";
> > +			};
> > ...
> > +		can0: can@2504000 {
> > +			compatible = "allwinner,sun20i-d1-can";
> > +			reg = <0x02504000 0x400>;
> > +			interrupts = <SOC_PERIPHERAL_IRQ(21) 
IRQ_TYPE_LEVEL_HIGH>;
> > +			clocks = <&ccu CLK_BUS_CAN0>;
> > +			resets = <&ccu RST_BUS_CAN0>;
> > +			status = "disabled";
> > +		};
> 
> Just a quick late night question to people with more knowledge than me:
> 
> These chips only have one pinctrl configuration for can0 and can1. Should
> the can nodes have this pre-set instead of the board dts doing this?

Yes, that's usually how it's done.

> 
> I see this happening in sun4i-a10.dtsi for instance, but it also seems like
> it could become a problem when it comes to re-using the dtsi for newer chip
> variants.

Properties can be either rewritten or deleted further down, so don't worry 
about that.

Best regards,
Jernej

> 
> John.