Re: [PATCH 1/2] mtd: use refcount to prevent corruption

From: Miquel Raynal
Date: Thu Jul 27 2023 - 02:19:52 EST


Hi Alexander,

alexander.usyskin@xxxxxxxxx wrote on Tue, 25 Jul 2023 12:50:04 +0000:

> Hi
> >
> > Hi Miquel,
> > >
> > > Hi Alexander,
> > >
> > > alexander.usyskin@xxxxxxxxx wrote on Mon, 24 Jul 2023 11:43:59 +0000:
> > >
> > > > > > > > With this patch applied, when I load up the module, I get the same 3
> > > > > > > > devices:
> > > > > > > > /dev/mtd0
> > > > > > > > /dev/mtd0ro
> > > > > > > > /dev/mtdblock0
> > > > > > > >
> > > > > > > > Upon removal, the below 2 devices still hang around:
> > > > > > > > /dev/mtd0
> > > > > > > > /dev/mtd0ro
> > > > > > >
> > > > > > Our use-case do not produce mtdblock, maybe there are some
> > > imbalances
> > > > > of get/put?
> > > > > > I have somewhere version with pr_debug after every kref_get/put. That
> > > may
> > > > > help to catch where
> > > > > > it missed, I hope.
> > > > >
> > > > > I believe mtdblock is the good citizen here. Just disable
> > > > > CONFIG_MTD_BLOCK from your configuration and you will likely observe
> > > > > the same issue, just a bit narrowed, perhaps. Indeed, if you manage to
> > > > > follow all the get/put calls it can help to find an imbalance.
> > > > >
> > > > > Thanks,
> > > > > Miquèl
> > > >
> > > > Miquel, do you have CONFIG_MTD_PARTITIONED_MASTER set in your
> > > config?
> > >
> > > Not sure I get your question. You can enable or disable it, it should
> > > work in both cases (yet, the handling is of course a bit different as
> > > the top level device will be retained/not retained).
> > >
> > > Thanks,
> > > Miquèl
> >
> > I'm trying to understand why I can't reproduce the problem in my scenario.
> > I found an important difference in upstreamed patch and internal version:
> > The IS_ENABLED(CONFIG_MTD_PARTITIONED_MASTER) check around
> > kref_get/put does not exists in the internal tree.
> > The code before my patch do not have such check, so I tend to assume that
> > this check should be removed.
> > If you reproduce happens with CONFIG_MTD_PARTITIONED_MASTER
> > disabled that may explain problems that you see.
> >
> > --
> > Thanks,
> > Sasha
> >
>
> I've tried to reproduce this with latest Linux 6.5-rc1 and my two patches.
> The manual modprobe mtdblock creates mtdblock0 over my partitions too.
> I can't reproduce problem neither with MTD_PARTITIONED_MASTER nor without.
>
> Let's try to debug on your system, can you enable dynamic debug for mtd subsystem,
> reproduce and publish dmesg?
>
> The prints for kref get/put can be added as below:
>
> diff --git a/drivers/mtd/mtdcore.c b/drivers/mtd/mtdcore.c
> index 2466ea466466..374835831428 100644
> --- a/drivers/mtd/mtdcore.c
> +++ b/drivers/mtd/mtdcore.c
> @@ -1242,10 +1242,13 @@ int __get_mtd_device(struct mtd_info *mtd)
> }
>
> kref_get(&mtd->refcnt);
> + pr_debug("get mtd %s %d\n", mtd->name, kref_read(&mtd->refcnt));
>
> while (mtd->parent) {
> - if (IS_ENABLED(CONFIG_MTD_PARTITIONED_MASTER) || mtd->parent != master)
> + if (IS_ENABLED(CONFIG_MTD_PARTITIONED_MASTER) || mtd->parent != master) {
> kref_get(&mtd->parent->refcnt);
> + pr_debug("get mtd %s %d\n", mtd->parent->name, kref_read(&mtd->parent->refcnt));
> + }
> mtd = mtd->parent;
> }
>
> @@ -1335,12 +1338,15 @@ void __put_mtd_device(struct mtd_info *mtd)
> while (mtd != master) {
> struct mtd_info *parent = mtd->parent;
>
> + pr_debug("put mtd %s %d\n", mtd->name, kref_read(&mtd->refcnt));
> kref_put(&mtd->refcnt, mtd_device_release);
> mtd = parent;
> }
>
> - if (IS_ENABLED(CONFIG_MTD_PARTITIONED_MASTER))
> + if (IS_ENABLED(CONFIG_MTD_PARTITIONED_MASTER)) {
> + pr_debug("put mtd %s %d\n", master->name, kref_read(&master->refcnt));
> kref_put(&master->refcnt, mtd_device_release);
> + }
>
> module_put(master->owner);
>
>

Could this be helpful?

https://lore.kernel.org/all/20230725215539.3135304-1-zhangxiaoxu5@xxxxxxxxxx/

If you successfully test it, please send your Tested-by.

Thanks,
Miquèl