Re: [PATCH v6 10/11] drm/mediatek: dp: Add .wait_hpd_asserted() for AUX bus

[Alexandre Mergnat]

Reviewed-by: Alexandre Mergnat <amergnat@xxxxxxxxxxxx>

On 17/07/2023 16:14, AngeloGioacchino Del Regno wrote:
> In order to support usecases in which the panel regulator can be
> switched on and off to save power, and usecases in which the panel
> regulator is off at boot, add a .wait_hpd_asserted() callback for
> the AUX bus: this will make sure to wait until the panel is fully
> ready after power-on before trying to communicate with it.
>
> Also, parse the eDP display capabilities in that callback, so that
> we can also avoid using the .get_edid() callback from this bridge.
>
> Since at this point the hpd machinery is performed in the new hpd
> callback and the detection and edid reading are done outside of
> this driver, assign the DRM_BRIDGE_OP_{DETECT, EDID, HPD} ops and
> register the bridge unconditionally at probe time only if we are
> probing full DisplayPort and not eDP while, for the latter, we
> register the bridge in the .done_probing() callback and only if
> the panel was found and triggered HPD.

--
Regards,
Alexandre