Re: [PATCH 1/7] ARM: dts: exynos: k3g: Add WiFi card support

[Krzysztof Kozlowski]

On 17/07/2023 00:05, Markuss Broks wrote:
> This device has Broadcom BCM4354 WiFi card installed,
> which uses SDIO interface.
> 
> Signed-off-by: Markuss Broks <markuss.broks@xxxxxxxxx>
> ---


>  &pinctrl_0 {
>  	s2mps11_irq: s2mps11-irq-pins {
>  		samsung,pins = "gpx0-7";
> @@ -628,6 +652,11 @@ touch_irq: touch-irq-pins {
>  		samsung,pins = "gpx1-6";
>  		samsung,pin-pud = <EXYNOS_PIN_PULL_DOWN>;
>  	};
> +
> +	wlan_reset: wlan-reset {

It does not look like you tested the DTS against bindings. Please run
`make dtbs_check` (see
Documentation/devicetree/bindings/writing-schema.rst or
https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
for instructions).

This is a requirement since few months (half a year?).

Best regards,
Krzysztof