Re: [PATCH v1 0/3] iio: adc: meson: tune init sequence

[George Stark]

Hello Jonathan

Thanks for your review

On 7/16/23 19:11, Jonathan Cameron wrote:
> On Sat, 15 Jul 2023 14:05:57 +0300
> George Stark <gnstark@xxxxxxxxxxxxxx> wrote:
>
> > This patch is a part of effort to support meson a1 SoC and make meson saradc driver
> > independent from vendor boot code initialization in common.
> >
> > Information was taken from vendor kernel 5.4, 4.19 and vendor uboot 2019.
> > Most of the bits are undocumented at all or it's not said how they affect measuring.
> >
> > All those bits are already initialized in bl* code and since kernel driver dosn't
> > rewrite or reset any registers but only changes some bits at init stage everything
> > works fine.
> >
> > Test procedure is rather simple - one can change those bits in runtime
> > (e.g. using devmem) and try to read channels (cat /sys/bus/platform/drivers/meson-saradc/.../iio:device0/*)
> > changing some of those bits leads to measure procedure errors or abnormal results.
> > Another test is build meson saradc as module, reset adc by reset bit, reload module
> > and compare measure results to those got before reset.
> >
> > George Stark (3):
> >    iio: adc: meson: init channels 0,1 input muxes
> >    iio: adc: meson: init internal continuous ring counter
> >    iio: adc: meson: init voltage control bits
> >
> >   drivers/iio/adc/meson_saradc.c | 73 ++++++++++++++++++++++++++++++++++
> >   1 file changed, 73 insertions(+)
> These look fine to me, but I'd like them to sit on list a little while
> on off chance anyone else has feedback on them.

I understand. I'd resend the patches in a week or more if there's no 
feedback.

If someone suggests tests so the community could trust the results I'll 
be happy to run them. I have odroid-c1, vim1, vim3 and a113l board.

> Thanks,
>
> Jonathan

--
Best regards
George